Common Problems of Car Wrapping Vinyl Construction

Many novice stores in the color change film construction process, there have been blistering events. In addition to the choice of Color Wrap Film, construction technology also has a lot to do with it. Today we will take a look at which locations are most prone to problems in the construction of Car Wrapping Vinyl (color change or car Paint Protection Film).

Corners of the front and rear Windows

Because of the difference of Angle curvature, depth and bump, the edge of car window is the part which is easy to tear in the construction of body film.

There are many reasons for foaming in this position, the main one is that the air is not completely scraped during construction. The remedy is the same as other parts of foaming, you can directly use the arc scraper for fine scraping, if it does not work, you can use a fine needle after puncturing, light scraping. It can be restored.

The skylight position is not pulled properly

The location of the skylight is also the hardest hit area of the film problem. The reason is that the location is very unfriendly to the construction personnel, and the most common problem is the imbalance of pulling the film, resulting in the occurrence of hollow situations.

The roof of the car is covered by a film, which is generally a large piece of film and a balanced flat paste. The sunroof of some old models is designed in the middle of the roof, and the construction personnel's hand length is not enough, and when two people pull both sides horizontally, there will be a lack of cooperation. This eventually leads to problems.